Dogtra Edge Owner's Manual

16 17* The transmitter and receiver/collar rubber-charging cap ensures dirt and debris does not build up in the charging port area. The unit is waterp

18 19To change the program setting, follow the steps below.4. The display on the LCD screen will now show the icon for the rheostat/volume or the sele

20 2111. Code SettingTo set the coding for the Dogtra EDGE transmitter to an existing receiver/collar, or an Additional receiver/collar, follow the st

22 2314. How to change the batteryThe Dogtra EDGE batteries are user replaceable.To replace the battery in the transmitter, follow the instructions be

24 25 7. Fasten the battery cover and the belt clip back on the transmitter with the four screws.* Caution - Do not detach the wire by pulling from

26 27 * Caution - Do not detach the wire by pulling from the battery. * Caution - The battery wires must run neatly along the top left side in to the

28 29by performing your commands. When these training procedures are complete, the e-collar is used as a reminder when the dog does not comply with yo

30 31Troubleshooting Guide1. My dog is not reacting to the collar.- Make sure the receiver/collar is turned on. To turn the receiver/collar on, hold

32 33Warranty And Repair InformationDogtra Company provides the original purchaser with a 2-YEAR WARRANTY. The warranty begins from the date of purcha

34

4 1By Dogtra Remote Controlled Dog Training CollarsOwner's Manual Please read this manual thoroughly before operating the Dogtra EDGE training co

2 3Intended UseDogtra e-collars are intended for behavior modication on dogs only. They are NOT intended for use on people or on animals other than d

4 5Table of ContentsAt a Glance………………………………………………………Main Features of the EDGE………………………………………Overview…………………………………………………………Understanding your training

6 7At a Glance- Included in the package -Transmitter Receiver/Collar Battery charger Splitter cable Test

8 9OverviewEDGE Transmitter1-dog buttonOn/off buttonRubber-charging capBelt clipBattery cover2-dog button3-dog button4-dog buttonLCDLED indicatorMode

10 11Understanding your training system1. How to turn the EDGE on/oTo turn the transmitter on, hold down the blue button on the back of the transmitt

12 13To activate the light-locate mode, hold down the front transmitter button. The location light will continuously ash while the button is pressed,

14 154. How to nd the right stimulation The EDGE unit comes installed with the rheostat dial on the transmitter. The rheostat intensity dial controls