Dogtra YS300 User Manual download pdf (Page 8)

TESTING

1. Turn the dogtra YS300 on by turning the ON-

OFF & Intensity Dial and select the test mode (T)

so that the arrow on the dial is aligned with the

letter “ T”.

The LED indicator light will flash for 1 second to

indicate that it is on, after 2 seconds it will flash

every 2 seconds. If the dog does not bark over 10

seconds, it will turn to the Sleep mode to save

battery life and the LED will turn off.

TESTING YOUR NO BARK COLLAR

TESTING

2. Test by scratching the rough surface of the test

tool on the collar (as shown in the diagram) using

a coin. The collar will emit a vibration three

times. Repeat the same process if you want to test

again.

3. The Dogtra YS300 has a preset delay of 15

seconds in-between corrections. Once the unit

activates, it WILL NOT activate again until 15

seconds has gone by. The reason for the delay is

so that your dog has some time to figure out the

implications of the corrections, before being

corrected again for barking.

 When on the test mode, the No Bark Collar

emits a vibration without emitting stimulation

at the same time.

 When on the test mode, the sensor may be

sensitive enough that the No Bark Collar can

activate easily by a small sound or tap.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Dogtra YS300 User Manual Page 8